|
Suction manifold
| D (mm) | D1 (mm) | L (mm) | L1 (mm) | n
| | 133 | 51 | 5030 | 1000 | 4
|
A section of the suction manifold to connect wellpoints
with a pump unit and providing a vacuum collecting pipeline for all takes.
|
| |
|
Elastic wellpoint 63
|
The wellpoint is made of elastic, semitransparent polyethylene tube with a filter protected by a mesh at its end.
|
| D (mm) | L (mm) | L 1(mm)
| | 63 | 6000 | 600
|
|
|
| |
|
Passage tube 133
|
The passage tube serves to extend the suction manifold of the wellpoint installation or to fill in a gap where there are no wellpoints installed.
|
| Symbol | D (mm) | L (mm)
| | 133/5000 | 133 | 5000
|
|
|
| |
|
Elastic connector 51
|
This connector is destined to connect wellpoint 63 to
the suction manifold of the wellpoint
installation . |
|
|
| |
|
Elastic connector 133
|
This connector is destined to connect the suction manifold
of the wellpoint installation with the pump unit or to effect any change of direction in which the suction and dump collector is laid.
|
|
|
| |
|
External stopper
|
A stopper 133 to plug the end of the suction manifold.
The 51mm external plug is used to plug the stub pipe of the suction manifold in case when at a given point no wellpoint is installed, or when due to a failure, the latter is out of operation.
|
|
|
| |
|
Rinsing hose
|
The rinsing hose is made of "Bezalin" and is used to connect the rinsing tube with the rinsing pump.
|
| Symbol | D (mm) | D1 (mm) | L (mm)
| | 75/8000 | 108 | 75 | 8000
|
|
|
| |
|
Rinsing tube 108
|
The rinsing tube is made of a 108 mm tube with a fitting and
grip for extraction at one end and serrated dents on the other end.
It is used to set wellpoints in the ground when bedding is required.
|
| Symbol | D (mm) | D1 (mm) | L (mm)
| | 108/6000 | 108 | 6000 | 6000
|
|
|
| |
|
133/90 bend
|
To change the direction of laid suction manifolds.
|
|
|
| |
|
Gasket of the 108/75 rinsing hose.
|
| |
|
Gaskets
|
Gasket of elastic hose
|
Gasket of the 108/75 rinsing hose.
|
|
| |
|
Flanged distributor
|
It has a flange like a stub tube at one end and
two inlets equipped with 133 mm internal fittings at the other end.
|
| D (mm) | D1 (mm) | D 2(mm) | L (mm) | L1 (mm) | L2 (mm)
| | 133 | 160 | 14 | 310 | 365 | 20
|
|
|
| |
|
Flanged stub tube
|
The stub tube is used to quickly connect a pump unit with a suction manifold of a wellpoint installation and a dump collector.
|
| D (mm) | D1 (mm) | D2 (mm) | L (mm) | L1 (mm)
| | 133 | 160 | 14 | 165 | 20
|
|
|
| |